After many decades of stagnation in this sector, finally an innovation that revolutionizes an important operation when overhauling a watch, replacing the old and obsolete spring winders that existed until now.
This tool was invented by us to insert the spring into its barrel during the periodic maintenance of the watch.
Due to its great versatility, simplicity and speed of use, it is highly appreciated by watchmakers and large repair workshops.

The springs can be wound in either right or left-handed directions.

For barrels from 5.5 to 15 mm

Spring height from 0.50 mm and up

The tool is composed of:

• 1 handpiece,
• 20 dowels from 5 to 20 mm.,
• 4 winders with pin and key
• reduction washers which are used only when the spring curl is not adequate for the size of the dowel.

Here's how to use it.

Once the appropriate plug has been chosen, it is inserted into the handpiece. The winder must also be chosen based on the size of the spring curl that will be inserted into the pin. The insertion can be right-handed or left-handed. Once the spring has been fixed onto the winder, it is necessary to insert the chosen plug into the handpiece. Once the height of the spring has been adjusted, it can be wound easily and safely. Once the operation is complete, the spring can be disarmed and the pin removed from the winder.

For info and further information
Watchmaker's Atelier
Via Cesare Correnti, 3 - Milan
Tel 028361732

www.orologiaio.it